Hawking Technologies HD45B Uživatelský manuál stáhnout pdf (Strana 14)

Chapter II: System and Network Setup

2-1 Build Network Connection

Please follow the following instructions to build the network connection between your

new HD45B access point and your computers and other network devices:

1. Connect your HD45B to the network port of your computer or connect wirelessly

to it.

2. Connect all your computers and network devices (network-enabled consumer

devices other than computers, like game console, or switch / hub) to the network.

3. Connect the A/C power adapter to the wall socket, and then connect it to the

‘Power’ socket of the access point.

4. Please check all LEDs on the front panel. ‘PWR’ LED should be steadily on, LAN

LEDs should be on if the device is connected to the network. If PWR LED is not

on, or any LED you expected is not on, please recheck the cabling, or jump to ‘5-2

Troubleshooting’ for possible reasons and solutions.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 96 97

Žádné komentáře

Hawking Technologies HD45B Uživatelský manuál Strana 14